The stuck pixel fixer flashes red, green, blue, white and black very fast over a small area or the whole screen. Switching a stuck subpixel on and off rapidly can sometimes free it. It will not fix every pixel, but it is free, quick to try, and does not touch the inside of your screen.
Photosensitivity warning. This tool flashes bright colors. Do not use it if you or anyone who can see the screen has photosensitive epilepsy or has ever had a seizure. The tool will not start until you confirm the warning, and any key, click or tap stops it at once.
How to use the stuck pixel fixer
- Find the pixel. Run the dead pixel test and remember where the spot is. A stuck pixel shows as a colored dot on black or on another color.
- Read and confirm the warning. The controls appear only after you do.
- Choose the area. Small area is best: drag the box over the pixel, or move it with the arrow keys (hold Shift to move faster). Full screen covers everything if the pixel is hard to locate.
- Choose a speed. It starts at 2 flashes per second. Faster rates (up to 10) are sometimes more effective, but start slow.
- Press Start flashing and look away. You do not need to watch.
- Stop and check. After 10 to 20 minutes, press any key and check the pixel on black and white.
How the fixer works
A stuck subpixel is usually a liquid crystal cell or OLED emitter that is not responding to the signal that should turn it on or off. Rapidly cycling the colors drives every subpixel in the area through its full range, over and over. In some cases that is enough to make a sluggish cell start following the signal again.
The color is worked out from the time since you pressed start, multiplied by the rate you picked. On a slow computer that can only mean fewer flashes per second, never more than you chose.
What to expect
| After running | What it means | Next step |
|---|---|---|
| Pixel is gone | It was stuck and has recovered. | Check it again over the next few days. |
| Pixel is fainter or flickers | It is responding. | Run the fixer a few more times. |
| No change after about an hour | Likely a dead pixel or a fault in the panel. | Check the warranty and return window. |
Our guide to dead pixel vs stuck pixel explains how to tell them apart and what each means for a warranty claim.
Tips
- Run it with the screen at normal brightness.
- Do not leave it running unattended for hours; repeated short sessions work as well.
- Cover the box area only. The smaller the area, the less flashing light in the room.
- On a phone, set the screen timeout longer so it does not lock mid-run.
Want to check the whole panel? Use the monitor test for uniformity and bleed. The home page lists every display test.
Fix guides for common problems
- Dead Pixel vs Stuck Pixel - What Is the Difference?: Dead pixel or stuck pixel? Learn how to tell them apart with a full-screen color test, what can be fixed, and when to use your warranty or return window.
- How to Check a New Monitor Before the Return Window Closes: Check a new monitor before the return window closes. A 10-step checklist for dead pixels, refresh rate, backlight bleed, banding, ghosting and ports.
Full Rig Check