The mouse test checks every button on your mouse, its scroll wheel in both directions, and catches the two most common faults: a worn switch that double clicks on its own, and a scroll wheel that jumps the wrong way. Point, click and scroll in the test area and watch each part light up.
How to use the mouse test
- Move your pointer into the test area.
- Click left, right and middle (press the wheel down).
- Click the side buttons, back and forward. They are blocked from navigating while you are in the area.
- Scroll up and down.
- Check that every part of the drawing turned blue and that each counter went up.
- Read the results for double click faults and wheel jumps.
How the mouse test works
The browser reports which button you pressed as a number from 0 to 4: left, middle, right, back and forward. The test listens for those presses and for wheel events inside the area. Each press is timed with the event’s high-resolution timestamp.
For double click detection, the test compares each click with the previous click of the same button. If the gap is shorter than the fault threshold (80 ms by default), it counts as a fault. A person deliberately double clicking takes much longer than that, so a gap this small usually means the switch bounced.
For the wheel, the test remembers the direction of recent scroll steps. A single step in the opposite direction in the middle of a steady scroll is flagged as a jump.
How to read your mouse results
| Result | What it means | What to do |
|---|---|---|
| All five buttons and both wheel directions blue | Everything registers. | Nothing. |
| A button never lights | No signal from that button. | Check mouse software, try another port, or test on another computer. |
| Double click faults | A worn or dirty switch is bouncing. | See fix mouse double clicking. |
| Wheel jumps | The wheel encoder is dirty or worn. | Clean it with compressed air; see the scroll wheel test. |
| Right button triggers left | Buttons swapped in system settings. | Check primary button settings. |
The double click threshold and why it is set at 80 ms are on the methodology page.
Common mouse problems and fixes
Clicks double up. Blow compressed air around the button, click it 50 to 100 times quickly to clear debris, and raise the debounce time in the mouse software if it has one. Persistent faults usually mean the micro switch needs replacing.
Clicks do not register. For wireless mice, replace the battery and move the receiver closer, ideally with a USB extension cable.
Pointer jumps around. That is a sensor issue, not a button one. Clean the sensor window and try a mouse pad.
Mouse terms in plain English
- Micro switch: the small switch under each button that clicks.
- Debounce: a short delay that ignores the switch’s bounce.
- Encoder: the part that reads the scroll wheel’s rotation.
- Side buttons: back and forward, often called mouse 4 and 5.
More mouse checks: mouse DPI test, polling rate test, scroll wheel test and double click test. See all tests on the home page.
Fix guides for common problems
- How to Fix a Mouse That Double Clicks on One Click: Mouse double clicking on a single click? Confirm it with a free double click test, then fix it with settings, cleaning, debounce or a new micro switch.
- What DPI Should I Use for Gaming?: What DPI is best for gaming? Learn what DPI, eDPI and cm/360 mean, why many players use 400 to 1600 DPI, and how to measure your real mouse DPI.
- Mouse Polling Rate Explained (125 Hz to 8000 Hz): What mouse polling rate is, how 125, 500, 1000 and 8000 Hz differ in delay and CPU use, which rate to pick for gaming, and how to test yours online.
Full Rig Check